在自上料混凝土攪拌罐車發生的事故中，很大一部分都是翻車原因造成的，混凝土攪拌罐車屬于專用車，它跟普通的貨車是不一樣的，很多人開得了大貨車，駕駛攪拌罐車還是有點困難的，它的相對較高，跟普通貨車的駕駛方法是有區別的。那么導致攪拌罐車翻車的具體原因有哪些呢？

In the accidents caused by self loading concrete mixing tank trucks, a large part of them are caused by overturning. Concrete mixing tank trucks are specialized vehicles, which are different from ordinary trucks. Many people can drive large trucks, and driving mixing tank trucks is still a bit difficult. Its center of gravity is relatively high, and the driving method is different from that of ordinary trucks. So what are the specific reasons for the overturning of the mixing tank truck?

1.駕駛員的操作不當，自上料混凝土攪拌罐車較高，且在行駛途中，攪拌罐是處于勻速轉動的狀態，假如遇到轉彎或者路況不好的情況下，控制不好車速和轉速就容易導致攪拌罐車翻車，新手攪拌罐車司機一定要掌握好車速。

1. Improper operation by the driver. The center of gravity of the self loading concrete mixing tank truck is relatively high, and the mixing tank rotates at a constant speed during driving. If encountering turns or poor road conditions, poor control of the speed and speed can easily cause the mixing tank truck to overturn. New hand mixing tank truck drivers must master the speed.

2.路況惡劣，攪拌罐車一般都是從攪拌站裝上混凝土，再運送到建筑工地上去，由于混凝土對環境有一定的污染，所以攪拌站一般都是建立在比較偏僻的地方，所以有的地方路況不是很好，攪拌罐車整車滿載時又比較重，在駕駛過程中加上路況不好，稍不注意就有可能造成翻車，如果自己的駕駛技術不熟練，對于這種路況的活兒好不要接。

2. The road conditions are poor. Mixing tank trucks usually load concrete from the mixing station and transport it to the construction site. Due to the certain pollution of concrete to the environment, the mixing station is usually built in relatively remote places, so some places have poor road conditions. When the mixing tank truck is fully loaded, it is relatively heavy. In addition, the road conditions are not good during driving, and if not paid attention, it may cause overturning, If one is not proficient in driving, it is not advisable to take on tasks related to such road conditions.

怎么樣才能避免翻車呢？

How can we avoid overturning?

攪拌罐車在重載時一定要注意，發動機轉速好在1000-1400轉/分范圍內工作，這樣發動機擁有大扭矩，在運送混凝土的過程中，車速好控制在40km/h，這樣才能大程度的保證行車安全，在轉彎之前一定要將車速降下來，然后再轉彎，攪拌罐車在裝運攪拌好的混凝土時，攪拌罐的轉速為2-10轉/分在運輸過程中，比較平坦的額路面上攪拌罐的轉速要保持在2-3轉/分，行駛在側傾坡大于50度的路面，或左右晃動較大的路面時，應停止攪拌罐轉動，等路況好轉后在恢復轉動。

When the mixing tank truck is under heavy load, it is important to pay attention to the engine speed range of 1000-1400 rpm, so that the engine has high torque. During the transportation of concrete, the speed should be controlled at 40km/h to ensure driving safety to a large extent. Before turning, the speed must be reduced before turning. When the mixing tank truck is transporting mixed concrete, the speed of the mixing tank is 2-10 rpm during transportation, On a relatively flat road surface, the speed of the mixing tank should be maintained at 2-3 revolutions per minute. When driving on a road surface with a slope greater than 50 degrees or a road surface with significant left and right shaking, the mixing tank should be stopped from rotating until the road conditions improve before resuming rotation.

自上料混凝土攪拌罐車翻車現象頻發的原因以及避免事項已經為您解答完畢了，希望能夠給您好的幫助，更多事項就來我們網站http://www.dbo1084.com咨詢了解吧！

The reasons for the frequent overturning of self feeding concrete mixing tank trucks and the precautions to avoid have been explained for you. We hope to provide you with good help. For more information, please visit our website http://www.dbo1084.com Consult and understand!